Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
You can adjust the angle of the air flow using the motor unit's mounting and tilting knob
4.
(13). Carefully loosen the knobs (H3) and (H4), adjust to the desired tilt, and then re-
tighten the knobs. Refer to the diagram below:
Thermal safety device:
Your fan is equipped with a thermal safety device that automatically cuts off the power
•
supply to the motor in the event of overheating.
Should this occur, take your fan to your retailer's after-sales service to have the fuse
•
replaced.
cleaning and maintenance
WARNING: The appliance must be unplugged from
the power point before cleaning or dismantling the
guards.
You can remove the front and rear guard to access the blades to clean them. Refer to the
•
"Assembly" section.
Remove dust with a soft, dry cloth.
•
For a more thorough cleaning, you can clean the blades and body of the appliance with a
•
soft sponge slightly moistened with water and a mild detergent (such as washing-up liquid).
Rinse with clean water and wipe thoroughly with a soft, dry cloth.
Make sure that water cannot come into contact with the motor.
•
Do not plug the unit back in until it is completely dry.
•
Do not clean with scouring pads or abrasive detergents to avoid damaging the chromed
•
metal coating.
16
V.3.0
cleaning and maintenance
H4
H2
H1
H3
Publicidad
Tabla de contenido
