Adjusting The Shock Setting; Setting The Parking Brake - BOB IRONMAN DUALLIE Guia Del Usuario

BOB Gear by Britax
7� Perform Roll Testing
If the stroller still consistently pulls
to the left or right when pushed
straight, proceed to next step.
8� Reorient The Front Wheel
Open the front wheel and front
brake quick releases. Remove
the front wheel and flip it around
so the quick release lever is on
the opposite side. Reinstall the
front wheel, secure the wheel and
brake quick release levers. See
Removing Front Wheel and Front
Wheel Installation sections.
Wheel Reoriented With Quick
Release Lever On Opposite Side
9� Perform Roll Test
If the stroller still consistently pulls
to the left or right when pushed
straight, proceed to Fine Tune
Tracking section.
Fine Tuning the Tracking
For fine tune tracking of stroller the
tracking knobs must be used.
If Stroller Pulls LEFT
1� Open Quick Release Lever
Open quick release lever on
front wheel. It is not necessary
to remove the front wheel. See
Removing Front Wheel section.
12
2� Adjust LEFT Knob
Turn the left knob clockwise one
full turn thereby pushing the
left side of the wheel forward.
Retighten quick release. See Front
Wheel Installation.
3� Repeat Roll Test
If stroller still pulls to the left,
repeat steps 1 and 2.
If Stroller Pulls RIGHT
1� Open Quick Release Lever
Open quick release lever on
front wheel. It is not necessary
to remove the front wheel. See
Removing Front Wheel section.
2� Adjust RIGHT Tracking Knob
Turn the RIGHT tracking knob
clockwise one full turn thereby
pushing the right side of the
wheel forward and retighten
quick release. See Front Wheel
Installation section.
3� Perform Roll Test
Repeat Roll test. If stroller still
pulls to the right, repeat steps 1
and 2.
IRONMAN DUALLIE/S.U.S. DUALLIE User Guide

Adjusting the Shock Setting

1� Remove Child From Seat
2� Set Shock Setting
Depress shock release knob
and simultaneously pull toward
back of stroller, sliding knob
into preferred position. Knob will
snap into place when in correct
position.
Position 1 is a SOFTER shock
setting recommended for
children 50 pounds (22�7 kg) or
less�
Position 2 is a FIRMER shock
setting recommended for
children weighing 51 to 100 lbs
(22�8 - 45�4 kg)�
NOTE: Every time stroller is
folded, stroller shocks default to
position 1.
3� REPEAT on opposite side�

Setting the Parking Brake

The parking brake prevents the
stroller from moving while loading
and unloading. The parking brake is
not designed as a stopping brake.
To set the parking brake, press the
brake bar down into the locked
position with your foot on the foot
pedal – making sure the locking pin
fully engages the locking disk.
LOCKED POSITION
To ensure the brake is set properly,
attempt to roll the stroller fore and aft
after setting the brake. If the stroller
will not roll, the brake is set properly.
To release the parking brake, lift up
on the red foot pedal with your foot
until the brake bar springs up into
the fully unlocked position.
UNLOCKED POSITION
13