Klein Tools BAT20-716 Manual De Instrucciones página 11

ENGLISH
OPERATING INSTRUCTIONS
• Material: The type of material and surface finish of the material will affect
fastening torque.
• Fastening time: Longer fastening time results in
increased fastening torque. Using a longer fastening
time than recommended could cause the fasteners
to become over-stressed, stripped or otherwise
damaged.
LIFT RING
The lift ring H is for moving the tool into difficult to reach
areas. Securely fasten lifting device to the ring before
moving the tool. Follow all worksite rules.
WARNING: To reduce the risk of serious personal injury, DO NOT use the lift ring
for tethering or securing the tool to a person or object during use when elevated.
• Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Contact Klein Tools for authorized service centers. Visit www.kleintools.com for
service manual and replacement part list.
• The charger and battery pack are NOT serviceable. To assure product safety and
reliability, repairs, maintenance and adjustments should be performed by a DeWALT
factory service center, a DeWALT authorized service center or other qualified
service personnel. Always use identical replacement parts.
IMPACT WRENCH: Blow dirt and dust out of all air vents with clean, dry air at least
once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.
Never use solvents or other harsh chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic materials used in these parts. Use a
cloth dampened only with water and mild soap. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
CHARGER: WARNING: SHOCK HAZARD. Disconnect the charger from the AC outlet
before cleaning. Dirt and grease may be removed from the exterior of the charger
using a cloth or soft non-metallic brush. Do not use water or any cleaning solutions.
H
MAINTENANCE
CLEANING
1. The best storage place is one that is cool and dry, away from direct sunlight and
excess heat or cold.
2. For long storage, it is recommended to store a fully charged battery pack in a cool
dry place out of the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery
pack will need to be recharged before use.
Do not place equipment and its accessories in the trash. Items must be properly
disposed of in accordance with local regulations. Please see www.epa.gov or
www.erecycle.org for additional information.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the nickel
cadmium, nickel metal hydride or lithium ion batteries (or battery packs)
indicate that the costs to recycle these batteries (or battery packs) at the end
of their useful life have already been paid. In some areas, it is illegal to place
spent nickel cadmium, nickel metal hydride or lithium ion batteries in the
trash or municipal solid waste stream and the RBRC program provides an
environmentally conscious alternative.
RBRC™ has established programs in the United States and
Canada to facilitate the collection of spent nickel cadmium,
nickel metal hydride or lithium ion batteries. Help protect our
environment and conserve natural resources by returning
the spent nickel cadmium, nickel metal hydride or lithium ion
batteries to an authorized DeWALT service center or to your
local retailer for recycling. You may also contact your local
recycling center for information on where to drop off the spent battery RBRC™
is a registered trademark of the Rechargeable Battery Recycling Corporation.
WARNING: EXPLOSION HAZARD. DO NOT INCINERATE BATTERY PACK.
STORAGE
DISPOSAL
11