English - Bosch GHP 5-55 Manual Original

OBJ_BUCH-2319-004.book Page 23 Thursday, September 22, 2016 3:30 PM

English

Safety Notes
Symbols on the machine
Read all safety warnings and
all instructions. Failure to fol-
low the warningsnd instruc-
tions may result in electric shock, fire
and/or serious injury.
General hazard safety alert.
Never direct the
water jet at peo-
ple, animals, the
unit or electric
components.
Warning: High pressure jets can be dan-
gerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network with-
out a system separator. Use a separa-
tor as per IEC 61770 Type BA.
Water flowing though a system sepa-
rator is considered not drinkable.
For self priming use special suction
kit 3 m long (F 016 800 335).
User qualification and personal pro-
tection
 This machine can be used by people
with reduced physical, sensory or
mental capabilities or lack of experi-
ence and knowledge if they have
been given supervision or instruction
concerning use of the machine in a
safe way and understand the hazards
involved.
Bosch Power Tools

The unit must not be operated by chil-
dren or juveniles. Children should be
supervised to ensure that they do not
play with the unit.

The unit may only be used by author-
ised persons who have received
training or have demonstrated their
ability to operate the unit.
Wear personal protective
equipment (PPE) e. g. safety
goggles, dust mask etc. to pro-
tect against water, particles and/or aer-
osols sprayed back from parts. Do not
inhale aerosols if self-priming from ex-
ternal sources. Such water can contain
disease-causing agents.
 Do not use the appliance within the
range of persons unless they also
wear protective clothing.
Connecting to the mains
 The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
 The operating voltage is 230 V AC,
(for non-European countries 220 V or
240 V, as applicable).
This is a class I unit and may only be

connected to properly earthed power
sources.

The electric supply installation shall
be made by a qualified electrician and
comply with IEC 60364-1.
 We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
1 609 92A 3EV | (22.9.16)
English | 23