Toparc RC-HD1 Manual Del Usuario página 12

WARNING - SAFETY RULES
GENERAL INSTRUCTIONS
Read and understand the following safety recommendations before using or servicing the unit.
Any modification or servicing that is not specified in the instruction manual must not be undertaken.
The manufacturer is not liable for any injury or damage due to a non-compliance with the instructions featured this manual.
In the event of problems or doubts, please consult a qualified person to handle the installation properly.
OPERATION
This remote control is designed to work with MIG / MAG and MMA welding processes. It can remotely operate the welding machine. The digital remote
control can be switched on and off using the ON/OFF button. When the digital remote control is switched on, the wire feeder's interface switches off. A
visual reprentation of the digital remote control appears on the wire feeder's interface. When the digital remote control is switched off or disconnected,
the wire feeder's interface switches back on.
Compatible machines : NEOFEED/PULSFEED.
SUPPORT INSTALLATION
The digital remote control support can be fitted on the trolley (option, ref. 032736).
1
EQUIPMENT DESCRIPTION (FIG-1)
1- Interface (MMI)
2- Remote control and power supply connector
3- ON/OFF button
CONTROL INTERFACE
• A : Use the left button for top menu navigation.
Selection and validation is done by pressing the button.
• B : Use the right button for top menu navigation.
Selection and validation is done by pressing the button.
- The default unlock code is : 0000
- To update welding parameters, insert the SD card and switch if off and on again.
- A complete reset requires 1 minute without switching off the machine and the presence of the SD card.
1 - Choosing welding settings
SYNERGIC or MANUAL
2 - Choosing welding process
PULSE (PLS) or STANDARD (STD)
3 - Choosing the material (Synergic mode)
Each material is associated with one gas and one choice of wire diameter.
Several materials are available :
- Fe - Steel with gas Ar+CO2 (18%) or CO2 gas (standard only)
- AlMg5 - Aluminium with gas Ar
- SS - Stainless steel with Ar+CO² (2%)
- CuSi – Cu Si 3 with gas Ar
- CuAl – Cu Al 8 with gas Ar
12
- AlSi 5 et 12 with gas Ar
RC-HD1
2
4- Remote control and power supply cable
5- Mounting support, compatible with the trolley (ref. 032736)
EN