Adding Locomotives Manually - marklin Central Station 3 Manual Del Usario

Adding Locomotives Manually

This is the way you add more locomotives
Locomotives without an mfx decoder are added by hand. To do this simply tap on the large plus sign
at the end of the locomotive list. You can also tap on the tool symbol („Edit") in the locomotive list and
select „Add locomotive" in the menu that is turned on. The locomotive settings are turned on, and the
„Info" tab is active. All settings are modified there (image below).
You determine the maximum speed to be
displayed on the locomotive controller in
the field „Speedometer".
Adding a locomotive with an MM decoder
A locomotive with an MM decoder can be added very easy to the
locomotive list by means of the integrated locomotive database.
First, select the MM decoder in the drop-down menu „Decoder
Type". At the end, tap on the symbol designated „Locomotive Da-
tabase" (left image and above). A search template will open (upper
right image).
A keyboard is turned on with a tap of your finger on the magnification lens. Here you enter the item number or
the locomotive name: The system immediately begins the search (Live Search). Each additional symbol makes
Adding a locomotive with an DCC decoder
In case of a locomotive with an DCC decoder you tap in the field „Locomotive Name" in order to enter the
name. By means of the name the CS3 will automatically search for the corresponding image in the integrated
You set the locomotive database (image below).
address by tapping on
the minus and plus signs.
Important: If the address
appears in red, it has
already been taken. Then
simply tap on „plus" until
the color changes back
to black. To the right
of that you will find the
drop-down menu „Num-
ber of functions" in which
you can set the number
of functions that can be
occupied.
In the search template tap on the
magnification lens, enter the loco-
motive name, and select from the
alternatives offered. Confirm with
Using your own locomotive images
You can add your own images to the image database of the CS3. The easiest way is to use the Web interface on
the CS3. See page 35 for details.
the search results more exact. After that, you select
the locomotive being searched and confirm with
„Ok".
Tip: It is best to do the search by means of the item
number, since this is straightforward.
„Ok" at the end.
If the CS3 cannot assign a
suitable image, a direct look
into the database may help:
You can open it with a tap of
your finger on the center of
the screen.
11