Unbalanced Input - AKG C 900 Modo De Empleo

2 Interfacing
2.1 General
Refer to sections
2.2 and 2.3.
2.2 Input with
Phantom Power
Fig. 2: Connecting
to a balanced input.
Refer to fig. 2.
2.3 Input with No
Phantom Power
Refer to fig. 2.
Important!
2.4 Unbalanced
Input
Fig. 3: Connecting
to an unbalanced
input.
Refer to fig. 3.
14
The C 900 is a condenser microphone and therefore needs a
M
power supply.
The microphone provides a balanced output on a 3-pin male
XLR connector:
Pin 1: ground
Pin 2: hot
Pin 3: return
You can connect the microphone either to a balanced micro-
phone input with or without phantom power or an unbalanced
microphone input.
C 900
M Phantom
C 900
M
1. Use an XLR cable (e.g., the optional MK 9/10 from AKG) to
connect the microphone to a balanced XLR input with
phantom power.
2. Switch the phantom power on. (Refer to the manual of the
unit to which you connected your microphone.)
1. If your mixer provides no phantom power, connect an
optional AKG phantom power supply (N 62 E, N 66 E, B 18,
B 15) between the microphone and the mixer.
Using any power supply other than those recommended
by AKG may damage your microphone and will void the
warranty.
C 900
M Phantom
You may connect AKG phantom power supplies to unbalanced
inputs, too.
2.3
2.2