Initial Cleaning And Heating; Working With The Laboratory Hot Plates; Control Panel Of The Slk 1 And Slk 2 Laboratory Hot Plates - SI Analytics SLK 1 Manual De Instrucciones

Initial cleaning and heating

When the laboratory hot plate is heated up for the first time or after a long period out of use, a temporary
smell will develop, which is caused by small particles of dust burning and water inside the insulation
system evaporating. To remove any accessible dust particles from the glass-ceramic heating area, use a
mild detergent to clean the glass-ceramic surface. Then rub the surface dry with a soft cloth.

4 Working with the laboratory hot plates

Control panel of the SLK 1 and SLK 2 laboratory hot plates

1
= Heating symbol.
2
Display for heat intensity settings
3
= LED lamp for "Programming heat intensity" activated.
4
= Sensor keys for heat intensity / timer operating time:
setting a higher heat intensity/ longer timer operating time.
setting a lower heat intensity/ shorter timer operating time.
5
= LED lamp for "Programming timer" "Heating zone" activated.
6
= Sensor key "Timer On / Off", Programming timer.
7
= Timer display indicating remaining time (in seconds),
8
= LED lamp for "Programming timer" "Egg timer" activated.
9
= Sensor key "On / Off".
10
= Sensor key: "Lock keys".
11
= LED lamp for "Lock keys" activated.
The symbols or
The symbol for hot surfaces is located on the upper side of the glass-ceramic heating surface.
1 2 3
for residual heat appear in the LED heat intensity display.
18
4 5 6
... .
...
7 8 9 10
.
11