Technical Data - Starmix ST 2400 Serie Instrucciones De Montaje Y De Uso

Technical data

Rated voltage:
Nominal current:
Rated output:
Heating output:
Motor output:
Air flow:
Speed of air flow:
Hand drying time:
Noise:
Weight (without packing):
Dimensions:
Protection class:
Esting marks:
Installation instructions.
Fix the installation pattern on the wall at the height
recommended in the table shown below on the left.
ATTENTION: for the model STH 2400 Z, the installat-
ion pattern must be revolved by 180°, so that the 20 mm
diameter hole drilled to take the power cable is located
at the top on the right instead of below on the left.
Mark the centre of the four fixing holes to be drilled with
a sharp-pointed instrument, then drill the holes using an
8 mm drill bit.
Operation + switch positions
Equipment
Electronic short duration timer,
running time: 30 – 60 sec.
Electronic short duration timer,
running time: 60 – 240 sec.
Electronic infra-red proximity switch
Sensor - safety cut-out
Safety temperature limiter
Series ST 2400
230 – 240 V~ / 50-60 Hz
9.7 A
2,400 watts
2,200 watts
200 watts
51 l/sec
20 m/sec
28 sec.
80 dB
6.6 kg
W 250, D 285, H 200 mm
IPX1
vg
Remove the lid from the appliance; to do this, unscrew
completely both the anti-theft screws on the mounting
plate. Use the special hexagon spanner supplied to do
this.
Next, fix the mounting plate to the wall, using the wall
plugs and screws supplied.
Connect the appliance to the power supply, taking care to
observe the information in the chapter entitled "Safety
instructions". THIS MAY ONLY BE CARRIED OUT BY A
QUALIFIED ELECTRICIAN
Place the cover on the appliance again, and fix it with the
two anti-theft screws. Tighten the screws by hand.
Hand dryer
ST 2400 ST 2400 E
X
X
X
X X
ST 2400 EC ST 2400 ES STH 2400 Z
X X
X X
X X
Hair
dryer
X
X
9