ECOVACS ROBOTICS DEEBOT 500 Manual De Instrucciones página 23

No. Malfunction
DEEBOT does not clean
5 automatically at the scheduled
time.
DEEBOT does not clean the
6
whole area.
DEEBOT is not able to connect
7
to the home Wi-Fi network.
Possible Causes
Time Scheduling function is cancelled.
The Continued Cleaning function is turned
ON and DEEBOT has just finished cleaning
the scheduled cleaning area.
DEEBOT is switched OFF.
The robot's battery is low.
The robot's Suction Intake is blocked and/or
there is debris stuck in its components.
The cleaning area is not tidy.
Incorrect home Wi-Fi username or password
entered.
DEEBOT is not within range of your home
Wi-Fi signal.
Network setup started before DEEBOT was
ready.
Your smartphone's operating system needs to
be updated.
6. Troubleshooting
Solutions
Program DEEBOT to clean at specific times using the
ECOVACS App.
This is normal. No solution necessary.
Switch ON DEEBOT.
Keep DEEBOT switched ON and connected to the
Charging Dock to make sure it has a full battery to work at
any time.
Power OFF DEEBOT, clean the Dust Bin and invert the
robot. Clean the robot's Suction Intake, Side Brushes and
the Main Brush as described in Section 4.
Remove small objects from the floor and tidy up the
cleaning area before DEEBOT starts cleaning.
Enter the correct home Wi-Fi username and password.
Make sure DEEBOT is within range of your home Wi-Fi
signal.
Turn ON Power Switch. Press the RESET Button for 3
seconds. DEEBOT is ready for network setup when it
plays a musical tune and its Wi-Fi Indicator light flashes
slowly.
Update your smartphone's operating system. The ECOVACS
App runs on iOS 9.0 and above, Android 4.0 and above.
23
EN