Comfort Glow QF4570R Instrucciones De Instalación Y El Manual De Propietario página 6

PREPARATION
Place the heater on a firm, level surface and plug into a 120V 60Hz power outlet. Only operate heater in upright position
with caster wheels attached.
Insert 2 AAA batteries into the remote control before using (Batteries Not Included).
OPERATING YOUR HEATER
Once the Electric fireplace has been properly connected to a electrical outlet, make sure the main power indicator
light (#1) on control panel is illuminated:
1. Start and select working mode
Or POWER
Or
2、Setting room temperature
Or
Turn the heater on by pressing the ON/OFF button on the
control panel or by pressing the Power button on the
supplied remote control.
Note: Once power is off, heating element will stop
working first, the fan will continue working for 3min to
dissapte internal heat.
Select a heat setting.
Press the HEATER button to toggle between the two heat
settings.
High Mode uses 1500W; Low Mode uses 1000W.
Adjust the thermostat by pressing the arrows on the
control panel or remote control.
Set temperature indication varies from 59°F to 95°F, or
from 15°C to 35°C. Once you have chosen the desired
temperature, the heater will remain on until the room
temperature increases to the temperature on the digital
display. The heater will cycle on and off to maintain the
desired room temperature.
6