Moser 1245 Manual De Instrucciones página 11

Changing the blade set
Replace a blunt or damaged blade set with an original spare part only. Spare parts can be ordered through your
dealer or Customer Services.
Before replacing the blade set, switch the appliance off.
Lubricate the new blade set before attaching.
Removing the blade set
· Press the release button (Fig. IV ) towards the blade set and lift the blade set out (Fig. IV ).
· Remove the blade set from the clip (Fig. IV ).
Attaching the blade set
· Attach the new blade set onto the clip (Fig. V ).
· The holder must be folded down (foldable with a flat screwdriver) (Fig. V ).
· Important note: Switch the appliance on (Fig. V ). Then lift the blade set up and press it on until you hear it snap
into place (Fig. V ).
Cleaning/maintenance
Regular cleaning and maintenance will guarantee long service life for the appliance.
Disconnect from the mains before cleaning the appliance. Do not clean the appliance when wet.
Do not use solvents or scouring agents!
· Clean the air filter regularly to ensure the supply of air:
· Remove the filter cover (Fig. III ) and clean the air filter with the cleaning brush.
· Reinsert the filter cover until it locks into position (Fig. III ).
· In order to maintain a good and long cutting performance and durability of the appliance, the blade set must be
cleaned and oiled regularly.
· Hair clippers should be oiled once a day.
· Animal clippers should be oiled every 15 minutes during use.
· Fold down the blade set (Fig. IV) and push the top blade to the side (Fig. VI ). Then remove cut hairs from the top
and bottom blade by using the cleaning brush (Fig. VI).
The top blade must not be pushed out completely!
The blade set must not be screwed on.
· After cleaning, return the top blade to its initial position (Fig. VI ).
· Oil the marked areas of the blade set with one drop of oil each (Fig. VII).
· The top blade should be aligned in the center of the bottom blade.
· Reattach the blade set as described above. Switch the appliance on briefly (approx. 10 seconds) to ensure the oil
film is evenly distributed.
· Only use our special blade set oil! This is available from your dealer or our Service Center.
· Clean the housing with a soft cloth, which may be dampened slightly.
Disposal in EU countries
Do not dispose of the appliance with domestic refuse. As part of the EU Directive governing the disposal of
electric and electronic appliances, the appliance is accepted free of charge by local waste collection points or
recycling centers. Correct disposal will ensure environment protection and prevent a potential harmful impact
on people and the environment.
Disposal in non-EU countries
· Please dispose of the appliance at the end of its service life in an environmentally friendly manner.
Accessories
· Blade sets (see page 54)
· Attachment combs (see page 55/56)
Hair clipper / animal clipper
en
11