Important; Checking Functioning; Maintenance; Spare Parts - Lotus PCT-63G Guia Para La Intalación E Instrucciones De Uso

Important!

After you have converted the cooker to work with a different type of gas the rating plate must be updated, specifying
the type of gas the appliance is now working with.
• The appliance contains the instructions necessary for use.
• Check the appliances for gas leaks.
• Check the lighting and flame of the main burner.
• We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialized personnel, observing the norms in force and our indications.
OPEN COOKING RINGS: the gas-cocks, control unit, ignition plugs, thermocouples and burners can be changed by
removing the grills and control panel.
GAS OVEN: the gas-cock, timer, thermocouples, burners and ignition plugs can be changed by accessing
them inside the oven and/or by removing the bottom oven panel or control panel.
•
Cut power off to the appliance
•
Remove the glass cover from the lamp holder
•
Unscrew the lamp
•
The new lamp must have the following characteristics:
•
be able to withstand a heat of up to 300°C
•
power: 15W.
•
voltage: 230V 50Hz.
Attention! The appliance must only be used under surveillance.

LIGHTING AND REGULATING THE GAS OVEN BURNER

To light, turn the knob to the left from the "0" position to any one of the positions between
and 250 (see figure); keep the knob pressed until the gas lights.
You can check the flame through the inspection hole on the bottom of the oven; after a few
seconds let got of the knob. If the flame goes out repeat the procedure. Turn the knob round to
the temperature position wanted.
To turn the oven off, turn the knob to the right until it reaches position 0.
Attention: - When the oven is working, the door must not be left open because it can heat
and probably damage the knobs.
GB

CHECKING FUNCTIONING

MAINTENANCE

SPARE PARTS

CHANGING THE OVEN LAMP

INSTRUCTIONS FOR USE

LIGHTING AND ADJUSTING THE OPEN RINGS

On the front panel, above each knob, there is a symbol which indicates to which burner the
knob corresponds.
To light, turn the knob to the left from position "0" to the
pushed down and press the button with the
The knob must be kept pushed down for a few seconds and then released . The flame may
go out, in which case it is necessary to repeat the procedure. By turning to the
the burner is brought to the minimum. To put out the burner, turn the knob back into the "0"
position
IE
IT CH
symbol until the gas lights.
34
symbol (see figure); keep it
position,