Cleaning And Maintenance - Beurer MP 41 Instrucciones Para El Uso

When filing, always work from the outside of the nail towards the tip!
Always check results regularly during treatment. As soon as the application
becomes unpleasant, stop the treatment.

8. Cleaning and maintenance

Before cleaning the power unit, always unplug it from the socket outlet!
– Clean the instrument with a slightly moistened cloth. You can also mois-
ten the cloth with mild soap suds to remove more stubborn dirt.
– If necessary, for reasons of hygiene, the attachments can be cleaned
with a cloth or brush moistened with alcohol. Dry them carefully after-
wards.
– Do not drop the instrument.
– Make sure that no water enters the instrument. But if this should happen,
do not use the instrument again until it is completely dry.
– Do not use chemical detergent or scouring agents for cleaning.
– Never immerse the instrument or plug-in power unit in water or other liq-
uids.
5 – Sapphire callus rasp
For rapid removal of stubborn calluses and hard
skin on the soles of feet and heels This attachment
can be used on large areas.
6 – Cylindrical milling cutter
Grinding of lignified foot nail surfaces as well as
smoothing of these. For this purpose, apply the
milling cutter horizontally to the nail surface and re-
move the unwanted layer of nail using slow circular
movements.
7 – Flame milling cutter
For removing ingrowing nails. Carefully guide the
flame cutter up to the part to be treated and remove
parts of the nail as necessary.
21