Mhouse RC2 Nstrucciones Y Advertencias Para La Instalación página 2

1 Warnings
• Before proceeding with the installation, make sure the product is
suitable for its intended use. Pay special attention to the data
provided in the "Technical Characteristics" chapter. MHOUSE
disclaims liability for any damage resulting from uses of the prod-
uct other than those described in this manual.
• Protect the product's internal components from contact with
water and other polluting substances. Keep it away from heat
2 Description and Intended Use of the Product
The RC2 receiver, used in combination with the TX4 transmitters,
is suitable for the remote control of single-phase equipment pow-
ered by the mains voltage, with up to 500W power.
The possible commands are On/Off, "Man Present", Timer 1 and
Timer 2. The receiver operates at a frequency of 433.92 MHz and
can memorize up to 30 "TX4" transmitters.
3 Installation
To connect the RC2 receiver, the normal power cable to the equip-
ment to be controlled must be "interrupted", as shown in figure 1.
Fig. 1
WARNING: Electrical systems must be set up by qualified
and experienced personnel in compliance with current leg-
islation. As the cable clamps do not provide protection
against pulling and the removable cable cap can be separat-
ed, the RC2 container must be positioned where it is inac-
cessible to the general public. Said container does not guar-
antee protection against access to those parts of the sys-
tem which are live. If the RC2 receiver is installed outdoors,
keep in mind that the cable holders are waterproof only for
round cables with a diameter of 6.5 to 8.5 mm.
1 Make sure there is no voltage anywhere in the electrical circuits
2 Cut the power cable to the equipment to be controlled
3 Open the RC2 enclosure and remove the "cable holding cap" as
shown in figure 2
Fig. 2
4 Strip the sheath off the two ends of the cable approx. 3 cm, then
strip the single conductors approx. 5 mm.
5 Thread the two cables through the holes in the cable holding
"cap" as shown in figure 3.
Fig. 3
2 RC2
sources and do not expose it to open flames. If any of these con-
ditions occur, stop using it immediately and call MHOUSE cus-
tomer service.
• Disconnect the power supply before proceeding with the instal-
lation operations.
• The packaging materials must be disposed of in compliance with
the regulations locally in force.
6 Pull the board out a few centimetres, as shown in figure 4.
Fig. 4
7 Connect the conductors to the terminals as shown in figure 5.
Fig. 5
8 Fold the conductors as shown in Figure 6.
Fig. 6
7 Push the board back inside the enclosure, making sure that the
stripped sections of cable are not exposed, then slide the "cap"
along the cables until the enclosure is closed tight.
8 The RC2 receiver does not require mounting, it can be positioned
directly in the dedicated compartment. To avoid any risk of water
infiltrations, we recommend positioning it with the cables facing
down. See figure 7
WARNING: The enclosure must not be perforated for any
reason.
Fig. 7