Frequently Asked Questions - Marmitek MEGAVIEW 80 Manual Del Usario

5. USAGE
1. Switch on the HDMI source (e.g. HD set-top box or multi media PC).
2. Switch on the display device (for instance HDTV or projector) and select the appropriate
input. Usually you will do this by pressing the A/V or EXT button of your remote control.
3. You will receive images from the connected A/V device immediately.

6. FREQUENTLY ASKED QUESTIONS

Bad (or no) image and sound
• Check if the A/V device is switched on.
• Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable Requirements).
• Check if the CAT5e/CAT6 cable provides a solid connection (no cable faults).
• Check if the RJ-45 has been connected according to the EIA/TIA T568B standard. Please
refer to attachment page 39
• Please ensure that the maximum cable length is not exceeded.
• Install your system as far away from any RF sources (wireless devices) as possible.
• Set a low resolution on your HDMI source. The CAT5e/6 cable used probably cannot deal
with the higher resolution bandwidth.
Do you have any questions that are not answered above?
Please check www.marmitek.com.
MegaView 80™ 5