Unpacking And Checking Contents; Tools Needed; Unpacking; List Of Loose Parts - RIDGID TP1300 Manual Del Usuario

Unpacking and Checking Contents

Tools Needed

Tools Required for Alignment
Straightedge

Unpacking

WARNING: To reduce the risk of injury from unex-
pected starting or electrical shock, do not plug the
power cord into a source of power during unpack-
ing and assembly. This cord must remain
unplugged whenever you are working on the thick-
ness planer.
Your thickness planer, is shipped complete in one box.
NOTE: Every RIDGID 13" thickness planer is tested at
the factory to insure its performance. You may see a
small amount of wood dust and chips on your new planer.
WARNING: If any part is missing or damaged, do
not plug the thickness planer in until the missing
or damaged part is correctly replaced. To reduce
the risk of electric shock, use only identical
replacement parts.

List of Loose Parts

NOTE: Before beginning assembly, check that all parts
are included. If you are missing any part, do not assem-
ble the thickness planer. Call 1-800-4-RIDGID or E-mail
us at info@ridgidwoodworking.com to get the missing
part. Sometimes small parts can get lost in packaging
material. Do not throw away any packaging until thick-
ness planer is put together. Check packaging for missing
parts before contacting RIDGID.
A
Wrench 8mm/10mm
Remove the protective oil that is applied to all unpainted
metal surfaces. Use any ordinary household type grease
and spot remover.
WARNING: To reduce the risk of fire or toxic reac-
tion, never use gasoline, naptha or similar highly
volatile solvents.
Apply a coat of paste wax to the table.
Wipe all parts thoroughly with a clean, dry cloth.
WARNING: For your own safety, never connect
plug to power source outlet until all assembly
steps are complete, and you have read and under-
stand the safety and operating instructions.
The following parts are included:
Item
A Thickness Planer ................................................ 1
B * Magnetic Knife Handling Tool ............................. 1
C * Hex "L" Wrench 4mm.......................................... 1
D * Open End Wrench 8mm/10mm .......................... 1
E Replacement Blades/Blade Case....................... 1
(stored under rear table)
F Owner's Manual.................................................. 1
G Bag of Loose Parts ............................................. 1
(Contains the following items)
H Handle ................................................................ 1
J Screw M5 x 0.8-10.............................................. 1
K Switch Key .......................................................... 1
* Supplied in "Tool Box"
B
C
D
8
Hex "L" Wrench 4mm
Description
F
E
G
J
H
K
Qty