MTD 19A30003OEM Manual Del Operador página 12

5. Open Hood by pushing in on the rear, right-side tab with
your right hand, as seen in 1 of Figure 4-16, and lifting the
cover with your left hand in the center rear of the bagger
cover, 2.
2
6. Install both grass bags onto the bag support assembly by
inserting the front edge in first (1), as seen in Figure 4-17,
and setting the back edge down (2) until it fits into the
assembly.
12 S 4 — A
ection SSembly
1
Figure 4-16
1
2
Figure 4-17
& i
nStAllAtion
Installing the Deck Chute
Note: Determine if your deck is a newer model, or an older
model. Refer to the upper inset of Figure 4-19. If your deck
has a mounting stud present, then you have a newer deck
model and you would follow the instructions below. If no
stud is present, refer to the instructions titled On Tractors
With Older Deck Configurations later in this section.
1. With the tractor's discharge chute raised up and held open (1),
install the chute elbow by placing the chute elbow mounting
rod into the hole provided in either your deck wheel bracket
or chute mounting tab (2), as seen in Figure 4-18.
Figure 4-18
2. Secure the chute elbow to the deck using the wing knob
720-04122 from hardware pack 689-00319. See Figure 4-19.
Note: If present, remove the protective cap off of the
mounting stud on the mowing deck as seen in the upper
inset of Figure 4-19.
2
Figure 4-19
1
2
1