Battery Use - GYS GYSTECH 7000 Manual Del Usuario

a- - Before connecting or disconnecting the battery leads, the power cord should be removed from
the mains.
b- Connect the red wire ("+") to the positive ("+") pole of the battery and the black wire ("-") to
the negative ("-") pole.
 Permanent connection to the vehicle battery (cable with eyelet terminals = accessories n°15)
Warning : during the mounting, do not connect the charger to the cable with eyelet terminals.
a- Connect the red cable to the positive battery's pole
b- Connect the black cable to the negative battery's pole
c- Fix your cable to the vehicle chassis
Make sure that the cable is not being pinched or in contact with warm surfaces or sharp edges.
d- After this, the quick contact of the charger can be connected.
 After charging, disconnect the battery charger from supply mains. Then remove the chassis
connection and the battery connection, in this order. In case of permanent connection to the
vehicle battery, first disconnect the battery charger from supply mains, then from the battery
connection.
S
UGGESTED MODES AND SELECTION
Gystech 7000 provides 5 modes : 2 charging modes and 3 specific modes.
To select your charging mode, please refer to the following table and explanations (page 4 and 5 :
charging modes and specific modes) :
M
ODES
12V
24V
13,6V /
Max
Recover
Supply
5A
* Remark: to recharge sealed batteries used in cycle, select the « cold » mode.
Select charging m ode
At the beginning of the charging process, the charger begins functioning in the last operation mode
(except in the 13,6V/Supply mode or 16V Boost mode) and automatically checks the voltage of the
battery (12V/24V). Press on
suggested in the following order :
12V batteries


EMERGENCY
(i.e.alarm)
LED




+
to select another mode between the charging modes which are
 

BATTERY USE

*
IN CYCLE
(=charging/discharging ;
i.e. : sweeper...)



« Alimentation » mode
(substitute battery)
BATTERY
AUTOMOBILE
(battery with VOLTAGE
&
or without SIZE
maintenance)
Normal
condition
12V
14 to 230 Ah
Cold
condition
Normal
condition
24V
14 to 120 Ah
Cold
condition
12V
14 to 230
Ah
12V
14 to 230

Ah
24V batteries
 
8/28