Ingersoll Rand Multi–Vane 2XJA1 Manual De Funcionamiento Y Mantenimiento página 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable
positions may be harmful to
your hands and arms. Stop
using any tool if discomfort,
tingling feeling or pain occurs.
Seek medical advice before re-
suming use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
GOVERNOR ADJUSTMENT
When installing a new Governor Assembly, screw the
Adjusting Nut onto the Stem to dimension "A" shown in
Dwg. TPD497. This will usually result in the proper
governed free speed of the Spindle. However, this is only an
approximate setting and, after checking with a tachometer,
further adjustment may be necessary. Screw the Nut farther
onto the Stem to increase the speed; back it off to decrease the
speed.
A=1–31/32" for Drills with Standard Throttle
A = 1–7/8" for Motors equipped with Remote Control
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
90 psig
(6.2bar/620 kPa)
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pres-
sure.
ADJUSTMENTS
(Dwg. TPD497)
WARNING
WARNING
WARNING
The correct governed free speed for the various Models at the
Spindle is:
Model
22JA1–EU, 2XJA1–EU
22KA1–EU, 22KWA1–EU, 2XKA1–EU
22MA2–EU, 2XMA2–EU
22NA1–EU
OILER ADJUSTMENT
To adjust oiler, remove the Backhead (12) and turn the
Oiler Adjusting Screws (14). Turning the Screws in
(clockwise) reduces the oil flow. Backing the Screws out
increases the oil flow. The oil flow can be controlled by
turning either Screw.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before instal-
ling, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
Speed,
rpm
1 025
725
350
280