Ingersoll Rand Multi–Vane 2XJA1 Manual De Funcionamiento Y Mantenimiento página 28

6. Slide the Spindle Assembly into the Gear Case and
install the Bearing Retainer in the groove in the Gear
Case with a small screwdriver inserted through one of
the holes in the Spindle Gear.
For Model 22N
1. Rotate the Spindle Gear (7l) until one of the holes in
the gear web aligns with the notch in the gear case
wall. Insert a small screwdriver into the notch and
pry the Bearing Retainer (73) out of the groove in the
Gear Case before attempting to remove the Spindle
Gear Shaft (70) from the Gear Case.
2. Press the Spindle Gear Shaft out of the Spindle Gear
and remove the Spindle Gear Key (72) from the Shaft
before attempting to press the Shaft out of the Spindle
Gear Bearing (69).
3. Support the short hub end of the Spindle (55 or 251)
and press on the front end of the Planet Gear Shafts
(64) when removing the Shafts from the spindle gear
head. The Planet Gear Rollers (66) and Roller
Retaining Plates (67) are free to drop out when the
Gears are removed from the Spindle. Use care to
prevent loss of these small parts.
MAINTENANCE SECTION
4. When assembling the Spindle, coat the inner wall of
5. Install the Spindle Bearing shielded side first on the
6. Press the Intermediate Gear Front Bearing into the
7. Lay the Bearing Retainer on the web of the recessed
28
the Planet Gears (65) with the recommended grease
and insert a Planet Gear Shaft through each gear bore.
Slide twenty–one Planet Gear Rollers into the space
between the gear wall and Shaft. Slip a Roller
Retaining Plate over each end of the Shaft and against
the Rollers. Carefully withdraw the Shafts and insert
the Gears into the gear frame on the Spindle.
Spindle. On the shielded side, the face of the bearing
inner ring is slightly lower than that of the outer ring.
On the opposite side of the Bearing the faces are
flush.
Gear Case before installing the assembled Spindle
Gear Shaft.
hub side of the Spindle Gear and press the Spindle
Gear Shaft into the Spindle Gear. Slide the assembled
Spindle Gear Shaft into the Gear Case. Insert a small
screwdriver through the holes in the Spindle Gear and
install the Bearing Retainer in the gear case groove.