Pre-Installation; Tools Required; Materials Required (Not Included) - Everbilt AUTOJ100A2 Guía De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Pre-Installation

APPLICATION
This unit is a single stage jet pump designed for shallow water well applications, where the water level is less than 25 ft. deep. If the water
level to the pump is deeper than 25 ft., a convertible jet pump or a deep well submersible pump should be used. A pressure switch pre-set
at 30psi "on", 50psi "off" has been installed on the pump. The pressure switch will automatically turn the pump on and off based on the
system pressure.

TOOLS REQUIRED

Flathead
Screwdriver
Safety goggles

MATERIALS REQUIRED (NOT INCLUDED)

One can PVC cement & primer (read instructions carefully)
One can thread compound (read instructions carefully)
Teflon tape
Rigid pipe
Check valve
Flexible plastic pipe/clamps
Tank tee
WARNING: All joints and connections must be AIRTIGHT. A single leak will prevent the proper operation of the pump. Wrap thread tape
clockwise on all threaded connections. For all non-threaded connections, you must use PVC Purple Primer and PVC Cement to ensure airtight
seals. Measure all pipe lengths before attaching.
NOTE: A foot valve is a check valve that is used to keep the water from running back into the well from the pump and maintain hydraulic
pressure when the pump is not running. If the foot valve does not hold the water the pump will lose it's prime and will not pump water. If the
foot valve open pressure is too high (the spring is too stiff), or the flow area is too small, the pump suction head and flow rate will significantly
drop.
NOTE: For SKU # 1000026697, SKU # 1000026692, SKU # 1001187555, the suction pipe size should not be less than 1-1/4 in. the suction size
of this pump is 1-1/4 in. FNPT. For SKU # 1001187540, the suction pipe size should not be less than 1in. the suction size of this pump is 1 in.
FNPT.
Phillips
Screwdriver
Tape Measure
4
Wrench
One well seal with vent plug
Foot valve
Discharge tee/Priming tee and plug
Relief valve
Adaptor
Tank(for AUTO series tank is included)
Thread Tape

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido