Delta ShopMaster SM300 Manual De Instrucciones página 6

2
5
7
1 - Drill Press Head and Motor
2 - Table Raising and Lowering Handle
3 - Table Clamp
4 - Chuck
5 - Chuck Key
6 - Pinon Shaft Handles (3)
7 - M8x1.25x125mm Carriage Head Screws (2), M8 Flat
Washers (2), M8.1 Lock Washers (2), M8x1.25 Hex Nuts
(2) (for fastening the base to a supporting surface)
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
DRILL PRESS PARTS
1
4
3
6
8 10
9
A S S E M B LY
A S S E M B LY TOOLS REQUIRED
1.) 2 hex wrenches - supplied
A S S E M B LY TIME E S T I M AT E
11
12
Fig. 2
8 - Worm Gear for Table Raising and Lowering
9 - Allen Wrenches (2)
10 - M8x1.25x25mm Hex Head Cap Screws (4)
11 - Table
12 - Base
13 - Column, Base Flange and Rack
2.) soft-tip hammer
1 hour or less
6
13