Causes And Rectification Of Faults; Disposal Of The Old Device - CASO DESIGN 1849 Instrucciones De Funcionamiento Originales

15.1 Causes and rectification of faults

Problem
Coffee brews too slowly (more than
10 minutes).
The device switches off before water
tank is empty.
The drip stop does not work
Water leaks out of the device.
Coffee grounds enter into the jug.
The coffee is not strong enough or
the coffee is too strong.
The coffee does not taste good.
The coffee is not hot enough.
Its difficult to place the jug on the
warming plate.
There is less coffee in the jug than
expected.
Attention
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

16 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
caso Coffee Compact
Possible solution
Descale the device (see chapter descaling)
Clean the grinding/brewing container and drip stop valve of
coffee residue.
Clean the valve under running water and press the drip
stop carefully several times.
Do not fill the water tank beyond the max level.
Check if grinding/brewing basket is overflowed because of
to much ground coffee.
Place the jug correctly on warming plate.
Do not remove the jug during brewing for longer as 30
seconds.
Have you used correct amount of coffee beans/ ground
coffee? It should be one heaped spoon of coffee for each
cup.
Check if you leave the jug on the warming plate to long,
especially if it contains only a small amount of coffee.
Check if you brewed too small amount of coffee. The
coffee is heated longer when you brew more of it.
Check if jug is placed correctly on warming plate.
Check if jug and grinding/brewing container are in correct
position.
Tilt the jug slightly to insert it. Caution: Do not spill the hot
coffee.
Is the jug correctly placed under the drip stop? Otherwise
the drip stop prevents the coffee from flowing into the jug.
The device needs to be descaled.
52