Inital Use Of The Scale; Inserting Batteries; Kg / Lb Switch; Use As Simple Scale - Microlife WS200 BT Manual Del Usario

• Always weigh yourself on the same scale each day at the same
time, preferably undressed and before breakfast. To get the
best results from your scale, weigh yourself twice, and if the
two weights are different from each other, your weight is
between the two readings. Wait for about 15 minutes after
getting up, so that the water can distribute itself around your
body.
• The surface of the scale can be slippery, if wet.
• If an error occurs during the analysis of your body fat and water
percentage, the scale will turn off itself automatically.
• The precision of this fat and water percentage measurement
can be altered in the following cases:
- a high alcohol level
- a high level of caffeine or drugs
- after an intense sports activity
- during an illness
- during pregnancy
- after heavy meals
- in presence of dehydration problems
- your personal data (height, age, sex) have not been input
correctly
- if you have wet or dirty feet
WARNING: The body fat and water percentage is to be
considered only as approximate information. For any
further information, please consult your physician or dieti-
cian.
WARNING: The measurement function of body fat and
water percentage may be utilized only by people that
belong to an age group that goes from 10 to 100 and that
are between 100 and 200 cm tall.

3. Inital use of the scale

Inserting batteries

This scale operates with 4 x 1.5 V alkaline batteries; size AAA.
When the batteries are dead the display shows «Lo».
1. Open the battery compartment 3 on the bottom of the device.
2. Replace the batteries – ensure correct polarity as shown by the
symbols in the compartment.
Do not discard the batteries together with the normal wastes,
discard with special wastes.
Remove the batteries if the scale is not used for long periods of
time.

KG / LB Switch

Located at the bottom of the scale, this switch 4 allows you to
choose the unit of measurement for weighing: kg or lb.
Select your desired unit of measurement, always when the scale
is turned on and «0.0» is displayed (otherwise the unit of measure
cannot be changed).

Use as simple scale

1. In order to get accurate measurements, place the scale on a
firm level floor.
2. Step onto the scale and wait without moving; after a few
seconds, the display screen will show your weight.
Do not lean on anything while being weighed as this could alter
the reading.
3. Step off the scale, the display screen will continue to show your
weight for a few seconds then it will turn off automatically.
3
4. If the «Err» symbol is displayed, it means that an error has
taken place during the measurement. Start the entire proce-
dure again from the very beginning.

4. Initial use with the app

1. Download the «Microlife Connected Health+» app. The app is
available on App Store (iOS) and Google Play™ (Android).
2. Activate Bluetooth
3. Open the «Microlife Connected Health+» app on your smart-
phone.
4. Place the scale on a firm level floor and step on the scale bare
footed. The Bluetooth
matically.
5. Stand still while the scale takes weight and body composition
measurements. The scale simultaneously searches for the
app/smart phone to establish connection.
6. Once the measurement is completed, the data is automatically
uploaded onto the app.
5. Calculation of Weight, Body Fat and Water
Percentage
1. Step on the scale with bare feet and ensure that you are
standing still with equal weight distribution and with both feet on
the ITO electrodes.
2. The scale weighs immediately. The weight is displayed first.
3. Weight, BMI, body fat, water, muscle, bone, BMR and visceral
fat will be shown in the «Microlife Connected Health+» app as
following:
- Weight in kg
- Body mass index (BMI)
- Body fat in %
- Body water in %
- Bone mass in kg
- Muscle percentage in %
- Basal metabolic rate in kcal (BMR)
- Visceral fat

There must be no contact between your left and right feet,
legs, calves of thighs; others the measurement cannot
preformed correctly.

The measurement result will be incorrect if the user
measures with socks on.

6. Safety, Care and Disposal

Safety and protection

• This device may only be used for the purposes described in
these instructions. The manufacturer cannot be held liable for
damage caused by incorrect application.
• This device comprises sensitive components and must be
treated with caution. Observe the storage and operating condi-
tions described in the «Technical Specifications» section.
• Protect it from:
- water and moisture
- extreme temperatures
- impact and dropping
- contamination and dust
- direct sunlight
- heat and cold
WS 200 BT
®
on your smartphone.
®
function of the scale is activated auto-