Replacing The Lamp Tubes/Starter - Beurer TL60 Instrucciones Para El Uso

7

Replacing the lamp tubes/starter

If you determine that your unit has a defective tube, you can replace it yourself. To do so,
proceed as follows:
WARNING:
• First switch off the unit and unplug it.
• Let the unit cool off.
• For safety reasons, do not remove any components or screws other than tho-
se specified below.
• Otherwise you are at risk of receiving an electric shock! In addition, failure to
observe this regulation shall void the warranty!
Lay the unit on a level surface.
1
Use a Phillips screwdriver to unscrew the 4
screws on the rear side of the unit.
Turn over the unit while holding on to the trans-
2
parent cover.
Carefully remove the cover to replace the tube.
3
Open the tube's two transparent retaining clips by
4
pulling up on them.
Carefully pull the tube up over the housing rim (1)
5
and out of the housing, then sideways out of the
frame (2).
Insert the new tube by following these steps in re-
6
verse order.
17
2
1