Service And Repair - Vollrath MIN0012 Manual Del Operador

CLEANING
WARNING
Electrical Shock Hazard
Keep water and other liquids from entering the inside of the
equipment. Liquid inside the equipment could cause an
electrical shock. Do not spray water or cleaning products.
Liquid could contact the electrical components and cause a
short circuit or an electrical shock.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pad to clean the exterior of the equipment.
These can damage the finish.
TROUBLESHOOTING
Problem
Grinder stops operating or output is erratic. Grinder is overloaded.
Metal shavings or particles in food product. Blade is installed backwards.
Motor hums but does not operate.

SERVICE AND REPAIR

Serviceable parts are available on Vollrath.com.
To avoid serious injury or damage, never attempt to repair the unit or
replace a damaged power cord yourself. Do not send units directly to
The Vollrath Company LLC. Please contact Vollrath Technical Services
for instructions.
When contacting Vollrath Technical Services, please be ready with the
item number, model number (if applicable), serial number, and proof of
purchase showing the date the unit was purchased.
www.vollrath.com
Might be Caused By
Blade is installed backwards.
Governor out of adjustment.
The Vollrath Company, L.L.C.
1236 North 18th Street
Sheboygan, WI 53081-3201 U.S.A.
Main Tel: 800.624.2051 or 920.457.4851
Main Fax: 800.752.5620 or 920.459.6573
Customer Service: 800.628.0830
Canada Customer Service: 800.695.8560
To maintain the appearance and increase the service life, clean this
equipment daily.
1. Turn off and unplug the grinder
2. Wash all components in the dishwasher or a in a solution of mild
dish soap and hot water.
3. Use a damp soft cloth to wipe the exterior of the grinder.
Course of Action
Switch to the "REVERSE" position momentarily, then turn the unit
to the "OFF" position. Check the following:
• Thumbscrew too tight; loosen and hand-tighten, do not over-
tighten.
• Discharge plate is blocked; remove and clear.
• Blade edges are dull; have sharpened or replace.
• Overloading and motor stops; allow unit to cool and press reset
button.
Press the Reset button.
Correct blade direction.
Correct blade direction.
Adjust governor per procedures posted at Vollrath.com or contact
Vollrath Technical Service.
WARRANTY STATEMENT FOR THE VOLLRATH CO.
This warranty does not apply to products purchased for personal,
family or household use, and The Vollrath Company LLC does not offer
a written warranty to purchasers for such uses.
The Vollrath Company LLC warrants the products it manufactures or
distributes against defects in materials and workmanship as specifically
described in our full warranty statement. In all cases, the warranty runs
from the date of the end user's original purchase date found on the
receipt. Any damages from improper use, abuse, modification or
damage resulting from improper packaging during return shipment for
warranty repair will not be covered under warranty.
For complete warranty information, product registration and new
product announcement, visit www.vollrath.com.
Technical Services
techservicereps@vollrathco.com
Induction Products: 800.825.6036
Countertop Warming Products: 800.354.1970
All Other Products: 800.628.0832
©
2018 The Vollrath Company L.L.C. Part No. 2350138-1 ml 3/13/18