Feiss OL13101 Manual Del Usuario

Installation Instructions for
Oakmont Outdoor Wall
Outdoor
G ENERAL RODUCT NFORMATION P
These fixtures are intended to be installed utilizing
boxes.
This product is safety listed for wet locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a
additional information.
1A
JUNCTION BOX
ANCHOR
ANCHOR SCREW
SCREW AND WASHER
17
Temporarily install the mounting plate to the junction box.
1
Mark the anchor hole locations on the mounting plate and remove the mounting plate.
2
3 Drill appropriate size holes at the marked locations and install the anchors.
Secure the mounting plate to the junction box.
4
Screw the anchor screws into the anchors.
5
Install one end of the fixture arm to the fixture loop and secure the other end to the fixture base using the cap nuts.
6
Connect the fixture to a suitable ground in accordance with local electrical codes.
7
8 Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
9
10 Mount the fixture base onto the mounting plate and secure it with the fixture screws.
Install the candle followers to the top of the candle tubes.
11
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
12
Insert the glass panels into the shade, then secure them by installing the brackets using the screws and washers.
13
14
Install the shade to the fixture using the shade screws.
Install a hex nut and washer onto the threaded pipe, then screw the threaded pipe to the bottom of the shade.
15
16 Place the cup onto the threaded pipe and secure it in place using the other washer and hex nut, then screw on the finial.
17 For wet locations, caulk around the base of the fixture with waterproof construction sealant.
I :
NEC compliant junction
LED dimmer. Consult lamp manufacturer for
FIXTURE SCREW
MOUNTING
PLATE
10
10
13
BRACKET
GLASS PANEL
SHADE SCREW
HEX NUTS AND WASHERS
FINIAL
O 13101, O 13102, OL13103 L
CAUTION RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
6
FIXTURE ARM
CAP
NUT
FIXTURE LOOP
FIXTURE
LAMP
CANDLE FOLLOWER
13
14
SHADE
15 THREADED PIPE
CUP
16
1
OL13101-OL13102-OL13103
L
-
1.0