Feiss OL10800 Manual De Instalación

Installation Instructions for
Federal 2 and 3 Light Outdoor Wall
Outdoor
G ENERAL RODUCT NFORMATION P
This product is listed by one of the following
" ationally ecognized esting aboratory" N R T
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is suitable for wet locations.
This product may be dimmed with a standard incandescent dimmer.
1A
FIXTURE HOUSING
Follow enclosed supplement installation instructions for electrical and fixture installation onto house junction box.
1
2 Install the candle follower by placing it on top of the socket.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage information. Repeat steps 2 and 3 for
3
remaining sockets.
Install all glass panels by carefully sliding them into the fixture housing and securing them using the clips.
4
Install the cover to the fixture housing and secure it using the cover screw.
5
6 For wet locations, caulk around the base of the fixture using waterproof construction sealant.
I :
L
5
COVER SCREW
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
COVER
CLIP
4
GLASS PANEL
LAMP
3
2 CANDLE FOLLOWER
SOCKET
1
OL10800_OL10801_OL10802_OL10804
OL10800, OL10801,
OL10802, OL10804 1.0