Ubicación De Los Controles - Ricatech RR2100 Manual De Uso

ESPAÑOL
UBICACIÓN DE LOS CONTROLES
PRESET –
LUZ
INDICADOR
STANDBY
TARJETA
SD
PRESET +
PROGRAMA
ARRIBA/F.F
ALARMA
ABAJO / F.R.
PUERTA DEL CD
PLATO ADAPTADOR PARA
DISCOS DE 45RPM
EJE
33 45 78
INTERRUPTOR DE CONTROL DE VELOCIDAD
( 33 1/3 , 45 , 78 RPM)
CONECTOR PARA
AURICULARES
ALTAVOZ
CONTROL
PANTALLA
FUNCIÓN POWER
DEL
LCD
VOLUMEN
REC/ PUERTO
SENSOR
BORRAR USB
PLAY/PAUSA
STOP/BANDA
ABRIR/CERRAR CD
REPETIR/ST
55
ENGLISH
TROUBLESHOOTING
There is no power
1. Make sure radio is plugged in correctly.
2. Look at the STAND BY INDICATOR and check to see if it is red.
3. If the red light is on, press the POWER /
There is no sound
BRAZO
1. Make sure the mute function is turned off.
2. Check that the volume is turned up by pressing VOLUME UP /
Note: Volume range on some units start at level 15 and ends at level 40.
SOPORTE
3. Make sure INT./EXT. switch on back of radio is switched to INT. (Unless you are using external speakers,
DEL
BRAZO
in which case it should be on EXT. )
4. Check to make sure power is turned on.
CD does not play
1. Check to make sure CD is inserted correctly (label side facing up).
2. Check to see that surface of CD is clean.
3. Make sure function switch is set to CD mode.
USB - There is no music playing when PLAY/PAUSE (USB) is pressed.
1. Make sure the MP3 device/Flash Drive has stored music files.
2. The unit will only play Flash Drives up to 512MB – 4GB
3. Reset USB by switching the unit Off or switching to another Mode.
4. Check if the file(s) is WMA file(s). The unit does not play WMA format, only MP3 format.
Remote not working
1. Replace battery.
2. Be sure to point the remote towards remote sensor when operating.
3. Remove obstacles in the path of the remote and radio so the remote signal has a straight path to the
radio.
Turntable will not work
1. Check it the AC Power source is connected.
2. Press the POWER /
should be off.
3. Check that the unit is in PHONO Mode. Try moving the Tone Arm to the right until a click is heard.
No Sound is coming from the unit
1. The white protective needle cover has not been removed
2. The Volume is not turned up
The Tone Arm will not move
1. The black tie-wrap has not been removed from underneath Tone Arm.
2. Tone Arm hold down clip has not been released
Trademarks – MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson
to turn the unit on.
on the remote.
(on front of unit or on RC) to turn the unit on, the STAND BY INDICATOR light
12