Servicing Of A Double-Insulated Appliance - Campbell Hausfeld PW1805 Instrucciones De Montaje Y Lista De Piezas

470100_1209.qxd 12/11/09
Operating Instructions and Parts List
Servicing of a Double-
Insulated Appliance
In a double-insulated product, two sys-
tems of insulation are provided instead of
grounding. No grounding means are pro-
vided for a double-insulated product, nor
should grounding means be added to the
product. Servicing a double-insulated
product requires extreme care and knowl-
edge of the system, and should be done
only by qualified service personnel.
Replacement parts for a double-insulated
product must be identical to the original
parts. A double-insulated product is
marked with the words "Double
Insulation" or "Double Insulated."
Product may also be marked with symbol
shown below.
Double Insulated symbol
that exceeds the operating pressure of
any of the parts (hoses, fittings, etc.) in
the pressurized system. Ensure all
equipment and accessories are rated to
withstand the maximum working
pressure of the unit.
• NEVER spray flammable liquids or use
pressure washer in areas containing
combustible dust, liquids or vapors.
• Never operate this machine in a closed
building or in or near an explosive
environment
2:34 PM Page 4
Do not use pressure
Explosion hazard.
Do not spray
electrical apparatus and wiring.
• Never disconnect the high pressure
discharge hose from the machine while
the system is pressurized. To
depressurize machine, turn power and
water supply off, then press gun trigger
2-3 times.
• Never permanently engage the trigger
mechanism on the gun.
• Never operate the machine without all
components properly connected to the
machine (handle, gun/wand assembly,
nozzle, etc.).
Equipment damage.
• ALWAYS turn water supply "ON" before
turning pressure washer "ON." Running
pump dry causes serious damage.
• Do not operate the pressure washer
with the inlet water screen removed.
Keep screen clear of debris and
sediment.
• NEVER operate pressure washer with
broken or missing parts. Check
equipment regularly and repair or
replace worn or damaged parts
immediately.
• Use only the nozzle supplied with this
machine.
• Never leave the wand unattended while
the machine is running.
• Never attempt to alter factory settings.
Altering factory settings could damage
the unit and will void the warranty.
• Always hold gun and wand firmly when
starting and operating the machine.
• NEVER allow the unit to run with the
trigger released (off) for more than one
(1) minute. Resulting heat buildup will
damage pump.
4
PW1805
www.chpower.com