Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
470100_1209.qxd
12/11/09
Operating Instructions and Parts List
! IMPORTANT !
This pressure washer is equipped with a
microswitch sensitive to water flow. This
Instant Start/Stop switch (ISS) senses
water flow in the pump. When the trig-
ger is released, water stops flowing
through the pump. The ISS then auto-
matically turns the motor off to protect
pump from overheating.
OPERATION
1. Pull trigger on gun.
2. Turn the "ON/OFF" switch to "ON".
3. Release trigger. The pressure washer
motor will stop running.
4. To spray again, pull trigger and motor
and pump will restart.
Note: Occasionally the motor may run
for a short time to bring fresh, cool
water into the pump even if trigger is
released. This is part of normal opera-
tion and will not damage the unit.
to "OFF" then trigger gun to release
hose pressure before unplugging
power cord.
make sure the "ON/OFF" switch on the
unit is "OFF" and unit is unplugged
prior to storage.
spraying when trigger is squeezed if
ON/OFF switch is in "ON" position.
Always point gun in safe direction.
Call 1-800-330-0712
for Technical Service
2:34 PM
Page 2
When using this product, basic
precautions should always be followed,
including the following:
1. Read all instructions before using the
2. ALWAYS disconnect power before
3. Follow all safety codes as well as the
4. Ensure safety devices are operating
5. Know how to stop this product and
6. Stay alert – watch what you are doing.
7. Do not operate the product when
Always turn the
"ON/OFF" switch
8. Keep operation area clear of all
Risk of equipment
9. Do not overreach or stand on
damage. Always
10. Follow the maintenance instructions
Risk of Injection.
11. This product is provided with a ground
Unit will start
12. Never use an extension cord with this
2
Important Safety Instructions
SAVE THESE INSTRUCTIONS
product.
disassembling or repairing the unit.
Occupational Safety and Health Act
(OSHA).
properly before each use. DO NOT
remove or modify any part of the gun
or unit.
bleed pressure quickly. Be thoroughly
familiar with the controls.
fatigued or under the influence of
alcohol or drugs.
persons.
unstable support. Keep good footing
and balance at all times.
specified in the manual.
fault circuit interrupter, GFCI, be sure
to inspect cord and GFCI prior to use.
Any repair or replacement of the
power cord must be performed by a
qualified (licensed or certified)
electrical technician.
product.
PW1805
www.chpower.com
Publicidad
Tabla de contenido
