Safety Instructions - Benning MM P3 Manual De Operación

This symbol on the BENNING MM P3 indicates that the BENNING MM P3

is equipped with protective insulation (protection class II).
This symbol appears on the display to indicate a discharged battery.
This symbol designates the „diode test" range.
This symbol designates the "continuity test" field.
The buzzer is intended for acoustic result output.
This symbol indicates the „capacity test" field.
(DC) Direct voltage

(AC) Alternating voltage
Ground (voltage against ground).
2.

Safety instructions

The instrument is built and tested in accordance with
DIN VDE 0411 part 1/ EN 61010-1
DIN VDE 0411 part 2-033/ EN 61010-2-033
DIN VDE 0411 part 031/ EN 61010-031
and has left the factory in perfectly safe technical condition.
To preserve this condition and to ensure safe operation of the device, the user must
observe the notes and warnings given in these instructions at all times. Improper han-
dling and non-observance of the warnings might involve severe injuries or danger
to life.
WARNING! Be extremely careful when working with bare con-

ductors or main line carrier! Contact with live conductors will cause
an electric shock!
The device must be used in electrical circuits of overvoltage ca-
tegory II with a conductor for a maximum of 600 V to earth or of
overvoltage category III with a conductor for a maximum of 300 V
to earth only.

Please observe that work on live parts and electrical components of
all kinds is dangerous!
Even low voltages of 30 V AC and 60 V DC may be dangerous to
human life.
02/ 2018
BENNING MM P3

14