Setup; Material Preparation - WAGNER FLEXIO Manual De Usario

SETUP

For a video showing how to set up the FLEXiO Handheld Sprayer, visit:
i
www.wagnerspraytech.com/flexio

MATERIAL PREPARATION

i Material to be sprayed may need to be strained to remove any impurities in the
paint which may enter and clog the system. Impurities in the paint will give poor
performance and a poor finish.
SPRAYABLE MATERIALS (WATER AND OIL-BASED)
•
Semi-Transparent stain
•
Solid stains
•
Lacquers
•
Urethanes
•
Decorative paints
•
Latex and oil-based paints
*THINNING THE MATERIAL
Before spraying, the material being used may need to be thinned. Never exceed the thinning advice
given by the coating manufacturer.
If thinning is necessary, use the proper solvent as specified by the material manufacturer.
Only thin the material if absolutely necessary to improve spray performance. Optimal
i
spray performance should be acheived simply by adjusting the various controls on
the unit.
Do not thin with materials that have a flashpoint below 100°F (38°C).
6
EN