Safety Notes; Important Notes; Functions - marklin BR 042 Manual Del Usuario

Safety Notes

• This locomotive is to be used only with an operating system desi-
gned for it (DC power = 18V±, Märklin AC, Märklin Digital,
Märklin Systems).
• Use only switched mode power supply units and transformers that
are designed for your local power system.
• This locomotive must never be supplied with power from more than
one transformer.
• Pay close attention to the safety notes in the instructions for your
operating system.
• The feeder track must be equipped to prevent interference with
radio and television reception, when the locomotive is to be run in
conventional operation. The 104770 interference suppression set is
to be used for this purpose.
• The wire used for feeder connections to the track may only be a
maximum of 2 meters / 78 inches long.
• Do not expose the model to direct sunlight, extreme changes in
temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
• The LEDs in this item correspond to Laser Class 1 according to Stan-
dard EN 60825-1.

Important Notes

• Due to the high power requirements for this heavy locomotive, there
are only limited possibilities for operation with the 60652 Mobile Station.
• The operating instructions are a component part of the product and must
therefore be kept as well as transferred along with the product to others.
• Please see your authorized Märklin dealer for repairs or spare parts.
Betrieb • Operation • Fonctionnement
• The warranty card included with this product specifies the warranty
conditions.
• Disposing: www.maerklin.com/en/imprint.html

Functions

• The mode of operation (AC/DC, Mfx, Märklin Motorola, or DCC) is
recognized automatically.
• Mfx technology for the Mobile Station / Central Station.
Name set at the factory: 042 096-8
• Possible addresses:
1-80 (Control Unit 6021)
1-255 (Central Station 6021x)
01 – 9999 DCC
• Address set at the factory: (Märklin) 42 & 43 / (DCC) 3
• Setting locomotive parameters (address, acceleration/braking delay,
maximum speed, etc.): with the Control Unit and DCC (CV program-
ming), Mobile Station, or the Central Station.
• Headlights, changing over with the direction of travel.
• Individual smoke functions can be activated with the sound func-
tions when the smoke is turned on (see page 39).
• When the locomotive is running, the control rod on the right side of the
locomotive is shifted prototypically in 5 positions by means of a motor.
• The doors on the locomotive and the tender can be replaced by doo-
rs included with the model (Page 36). The larger doors may cause
problems when the locomotive is running.
• The model is designed for operation on Märklin 1 Gauge track. As the
consumer you assume the risk for operating on other makes of track.
• Minimum radius for operation: 1020 mm / 40-1/6".
• Only the train control functions and headlight changeover feature
are available in analog operation.
16
Exploitatie • Operación • Operazione