Tripp-Lite U339-002 Manual Del Propietário página 5

Offline Cloning
Notes:
• If your SATA hard drive has not been formatted yet,
you will need to format it using your computer's Disk
Management utility before proceeding with cloning.
• The Slave Drive's (Bay B) capacity must be larger
than the Master Drive (Bay A). If its capacity is
smaller or equal to the Master Drive, you will not be
able to clone information onto it.
• Prior to cloning, ensure there is no important data
stored on the Slave Drive. Once cloning begins, all
data on the Slave Drive will be deleted and replaced
with the cloned data from the Master Drive.
• Be aware that the cloning process will take some
time (approximately 2.5 hours per 1TB). Do not
turn off power or remove hard drive before the LED
progress bars indicate the process is completed.
• Offline cloning feature will not work if the U339-002
is connected to a computer or any other source via
USB cable
1. Connect the included power supply to
2. Insert the 2.5" or 3.5" SATA Master hard
18-11-290-933613.indb 5
the unit and plug it into a Tripp Lite Surge
Protector, PDU, or UPS.
drive (the drive you want to clone) into The
Master Drive (Bay A) of the docking station.
5
12/7/2018 5:34:50 PM