Hammerhead HCSD040 Manual Del Usario página 15

OPERATING INSTRUCTIONS
4. Installing and Removing Bit
a. To install a screwdriver bit, push
it into the collet until it is firmly
in place.
b. To remove a screwdriver bit, pull
it straight from the collet.

CAUTION: To avoid possibly
serious injury, take care not to activate
the forward/reverse selector when
installing or removing bits.
5. Magnetic Insert Bit Holder
The magnetic insert bit holder
functions to extend the bit in tight
places. It is compatible with ¼-inch
shanks.
a. To install the magnetic insert bit
holder, push it into the collet until
it is firmly in place.
b. Insert a 1/4" bit into the bit holder.
The magnetic bit holder holds the
head of the bit against the shaft.
c. To remove the magnetic bit holder,
pull it straight from the collet.

CAUTION: To avoid possibly serious injury, take care not to activate the forward/
reverse selector when installing or removing bits.
4V ELECTRICIAN'S SCREWDRIVER
4
5
MAGNETIC INSERT
BIT HOLDER
1/4 IN HEX
COLLET
15