Care And Maintenance - Hammerhead HCSD040 Manual Del Usario

OPERATING INSTRUCTIONS
9. Wire Stripping
The tool is fitted with a wire stripper
for stripping 12, 14, 16, 18 and 20
AWG wire sizes.
a. Select the opening in the stripping
lever that matches the wire size.
b. Insert the wire and depress the
wire stripper lever to clamp the
wire stripper around the wire.
c. While holding the wire firmly,
slowly swing the tool around the
wire to cut the insulation
d. Pull the tool back to strip the wire
insulation.
10. Wire Bending
The wire bending hole is located on
the bit holder.
To bend a wire, insert it into the wire
bending hole, hold the wire with one
hand and move the tool to bend the
wire as needed.

CARE AND MAINTENANCE

All maintenance should only be carried out by a qualified service technician
Cleaning
Before cleaning or performing any maintenance, take care not to rotate the forward/reverse
selector. For safe and proper operation, always keep the tool clean.
Always use only a soft, dry cloth to clean your screwdriver; never use detergent or alcohol.
4V ELECTRICIAN'S SCREWDRIVER
9
OPENING
10
WIRE
WIRE STRIPPER
LEVER
19