Cable Guide Mount Installation - SRAM QUARQ Manual Del Usario

C A B L E G U I D E M O U N T I N S T A L L A T I O N
The Cable Guide Mount should only be used when the cable guide is fastened with a screw. If the cable
guide is fastened with a rivet, use the Bottom Bracket Cup Mount or Adhesive Putty instead.
Installation Notes: Do not allow the magnet to contact the power meter. When properly installed, the
magnet should be in line with the cadence sensors and within 2-­8 mm (1/16"-­3/8") of the sensors.
1.
2. Loosen the cable guide screw. It may be helpful to shift the front derailleur to the small chainring
position, and the rear derailleur to the smallest cog. This will reduce the cable tension, and make it
easier to slide the cable guide mount under the cable guide.
3. Slide the mount under the cable guide.
4. Reinstall the cranks.
5. Tighten the cable guide screw.
6.
8

CABLE GUIDE MOUNT INSTALLATION

2-8 mm
(1/16"-3/8")