Xloc Full Sprint™ Installation; Remove The Xloc(S) - SRAM ROCK SHOX X Loc Full Sprint Manual Del Usuario

x L o c f u l l S p r i n t ™ i n s t a l l a t i o n
If your fork or rear shock has an XLoc, the XLoc(s) must be removed from the fork and/or rear
shock prior to XLoc Full Sprint installation.
R e m o v e t h e X L o c ( s )
1. Use a T25 TORX® wrench to remove the clamp bolt from the rear XLoc. Remove the rear
XLoc from the handlebar.
2. If applicable, use a T25 TORX wrench to loosen and remove the clamp bolt from the front
XLoc. Remove the front XLoc from the handlebar.
3. Slide the hose boot off the rear shock banjo fitting. Use an 8 mm open end wrench to
loosen and remove the compression nut. Pull the hose from the shock.
Fluid will drip from the hose.
3
XLoc FuLL Sprint™ inStaLLation
7