Light Kit Assembly; Important - Craftmade ELLINGTON LAVH44BNK4 Guia De Instalacion

9. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in center of fitter plate with loosened screws
in motor plate, allowing the male plug from
motor housing to come through hole in
middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed
and securely tighten all 3 screws with a Phillips
screwdriver. (diagram 1)
Remove 1 screw from post located on
underside of fitter plate and partially loosen
the other 2 screws on the other 2 posts.
Connect male plug from motor housing to
female plug from the light kit fitter. Make sure
plugs connect tightly. Align slotted holes in
light kit fitter with loosened screws in fitter
plate. Twist light kit fitter to lock. Re-insert
screw that was previously removed and
tighten all 3 screws securely. (diagram 2)
Install two 13-watt compact fluorescent bulbs,
size GU24 (included). (diagram 2)
IMPORTANT: When replacing bulbs, please
allow bulb(s) and glass shade to cool down
before touching them.
Locate grooves on glass shade and align with
nodules on inside of light kit fitter. Push up
gently on glass shade. Turn glass shade in a
clockwise direction until it slides completely
into place. (diagram 3)
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
motor plate
diagram 1
male plug
female plug
diagram 2
motor housing
diagram 3
page 6
motor housing
fitter plate
motor housing
fitter plate
light kit
fitter
bulb
light kit fitter
nodule
groove
glass shade