Installing The Memory Card Retainer - Rockwell Automation Allen-Bradley PanelView 300 Instrucciones De Instalación

Installing the Memory Card Retainer

The memory card retainer is required for UL508 installations where a memory card
is inserted in the card slot. The retainer protects against Electrostatic Discharge
(ESD) up to 15KV and prevents accidental removal of a memory card in high
vibration environments.
To attach the memory card retainer:
Memory Card
Retainer
1. Secure the base of the retainer over the existing memory card slot using the
two screws provided. Tighten screws to a torque of 6 to 8 in-lb (.7 to .9 Nm).
2. Insert the memory card and install the retainer until it is properly seated.
3. To remove the retainer, press the tabs on each side and pull.
Retainer Base
Base Mounting Screws
PanelView 300 Keypad Terminals
Publication 2711-IN027B-MU-P
11