Connecting Dc Power - Rockwell Automation Allen-Bradley PanelView 300 Instrucciones De Instalación

12 PanelView 300 Keypad Terminals

Connecting DC Power

All of the PV300 terminals (e.g., Catalog No. 2711-K3AxxL1) connect to a 24V dc
power source.
The table below shows the electrical ratings for the DC versions of the terminals.
Electronic circuitry and an internal fuse protect the terminals from reverse polarity
and over-voltage conditions.
Terminal Type
PV300 Keypad
The PanelView 300 terminal is designed for safe use when installed in a suitably
rated NEMA Type 12, 13, 4X (indoor use only), IP54 or IP65 enclosure.
ATTENTION
!
ATTENTION
!
Publication 2711-IN027B-MU-P
Supply Voltage
18 to 32V dc,
(24V dc nominal), Class 2 Power Supply
Do not connect the PanelView terminal to an AC power
source. Connecting to an AC power source may damage the
terminal.
Use only a Safety Extra Low-Voltage (SELV) power supply as a
source for the PanelView 300 terminal. A SELV power supply
does not exceed 42.4V dc.
Power Consumption
6 Watts (0.25 Amps at 24V dc)