Memory Function; Auto-Off Function - Imetec R5701 Manual De Instrucciones

IMPORTANT - The time required to heat the heated mattress cover may vary depending
on the ambient temperature conditions. The temperature of the heated mattress cover
must be evaluated by lying in the bed rather than just feeling it by hand.
EN
For night-time or continuous operation of the device, set the
control to temperature levels 1 to 3 only.
WARNING!
at a temperature higher than the one recommended for night-time
or continuous use.
If the appliance is used with the command set at a higher
temperature, the user may be at risk of burns or heat stroke.
• To select the desired continuous use temperature from 1 to 3 press the temperature
selector key (12) until the desired LED lights up (9). The higher the number selected,
the higher the temperature.
• If the heated mattress cover is in standby mode, it must first be switched off via the
power switch on the rear (14) to turn it on again.

MEMORY FUNCTION

After a few minutes of use, the anti-mite heated mattress cover stores the last
selected temperature, which will be proposed automatically the next time the control
is switched on.

AUTO-OFF FUNCTION

The anti-mite heated mattress cover is equipped with an automatic switch-off system
differentiated according to use.
• The timer that is activated automatically by selecting temperature 6 turns the control off
after 2 hours from the power being turned on.
• The timer that is activated automatically by selecting one of the temperatures from 1 to
5 switches the control off after 9 hours from the selection of the desired temperature. If
you change the temperature selection from 1 to 5 the timer continues to count.
• The timer that is activated automatically by selecting the anti-mite function turns off the
control after 6 hours from the selection of the anti-mite function.
When the time has elapsed, the heated mattress cover turns off and the stand by LED
(13) lights up blue.
• If the device is in standby mode, to select any function, first turn off the control using
the switch on the back (14) and then turn it on again.
25
DO NOT get into the bed when the appliance is set