Kohler Sterling 572102 Guía De Instalación Y Cuidado página 7

1/2"
(13 mm)
4. Install the Pivot Side Wall Jamb
Position the pivot side wall jamb on the wall 1/2" (13 mm) from the front ledge of the shower base.
Plumb the wall jamb using a level.
Temporarily secure the wall jamb with masking tape.
Mark the location of the four wall jamb slots on the wall.
Remove the masking tape, then move the wall jamb to a safe area.
IMPORTANT! The supplied 6 mm drill bit is not suitable for drilling through tile. For tile installations,
use a 6 mm tile bit.
Slowly drill the marked hole location, using the provided 6 mm drill bit for non-tiled walls.
Insert an anchor into each hole. Make sure the anchors are flush with the finished wall.
Secure the wall jamb to the wall using the four washers and #8 x 1-1/2" screws.
Install a cap on each of the screws.
Sterling 7
6 mm
1280802-2-B