RCA RSWW1 Guia De Instalacion página 15

D. Place the floor sensor on the floor near the hot water tank.
E. Place the other sensor over the end of the hot water tank's pressure-release
output pipe.
F. Plug in the smart module.
1. Plug the smart module's power adapter into the jack on the side of the smart module.
IMPORTANT: If you're using the hot water shut-off system without the smart module, plug the power adapter directly
into the DC In jack on the control unit.
2. Plug the other end of the power adapter into an available power outlet.
If both power outlets are in use, use the included 3-outlet power wall tap to provide additional outlets.
When the smart module and control unit first power on, the yellow indicator light on the front panel of the control unit
flashes—the auto shut off valve system is arming. When the green indicator light comes on, the system is ready to use.
Make sure the sensor is sitting flat on the floor near the hot water tank.
Use a cable tie to secure the sensor cable to the pipe so that the sensor hangs over the end
of the pipe as shown.
Note: This sensor activates the alarm and servo motor only after detecting water leakage for
1 minute continuously on the pressure release output pipe of your water heater. Releasing
high pressure is important but anything longer than a minute can indicate a faulty pressure
release valve that's not closing properly.
15