RCA RSWW1 Guia De Instalacion página 6

Step 2: Assemble the Servo ring & brackets
A. Install the brackets on the shut-off servo
Find the following pieces in the hardware bag:
2 pipe-mounting
brackets
Find the bracket slots on the servo, shown here. The
brackets should be mounted on the inside of these
slots.
6
2 wing nuts
2 short carriage
bolts (M5 x 24)
Bracket slots
Place one bracket over the inside of a servo slot. Insert a
short carriage bolt through the bracket and servo slot. Place
a flat washer, lock washer, and wing nut on the end of the
bolt and tighten just enough so that the bracket stays in
place. Then repeat with the other bracket.
Short
carriage bolt
2 flat washers
2 lock washers
Wing nut
Lock washer
Flat washer