Maintenance / Recommendations; Electricity Supply - GYS Easymig 130 Manual Del Usuario

MAINTENANCE / RECOMMENDATIONS

• Maintenance should only be carried out by a qualified person. Annual maintenance is
recommended.
• Ensure the machine is unplugged from the mains, and wait for two minutes before carrying
out maintenance work. DANGER High Voltage and Currents inside the machine.
• Remove the casing 2 or 3 times a year to remove any excess dust. Take this opportunity
to have the electrical connections checked by a qualified person, with an insulated tool.
• Regularly check the condition of the power supply cable. If the power cable is damaged, it
must be replaced by the manufacturer, its after sales service or an equally qualified person.
• Ensure the ventilation holes of the device are not blocked to allow adequate air circulation.
• Do not use this equipment to thaw pipes, to charge batteries, or to start any engine.
INSTALLATION – PRODUCT OPERATION
DESCRIPTION
Thank you for chosing this machine. To get the best use from your machine, please read the following carefully :
The Easymig range are semi-automatic MIG/MAG, MMA and flux cored wire welding stations. They are manual
settings machine, with the help of the table printed on the product. They are recommended for welding steel,
stainless steel and aluminium.

ELECTRICITY SUPPLY

The absorbed current (I1eff) is indicated on the device at maximum usage. Check that the power supply and
its protection (fuse and/or circuit breaker) are compatible with the current needed for use. In some countries, it
might be necessary to change the plug to allow maximum performance. The device must be installed so that the
mains socket is accessible.
Do not use an extension cable with a diameter of less than 1.5mm². Easymig is delivered with a 16amp plug
(TYPE CEE7-7).
This machine must be connected to an EARTHED power supply 230V, 50/60 Hz, and protected by a 16A circuit
breaker .
MACHINE DESCRIPTION (FIG I /
1 : Adjustment of welding settings (wire speed and
welding voltage).
2 : Switch MIG/ MMA
3 : European standard torch connection.
4 : Connectors
SEMI-AUTOMATIC WELDING FOR STEEL / STAINLESS STEEL (MAG MODE)
Set the voltage output and the wire speed according to the thickness of the weld piece, following the instructions/
recommendations printed on the side of the machine.
The Easymig can weld Steel wire 0.6/0.8mm, and Stainless Steel of 0.8mm.
The machine is fitted with Ø 0.8mm Steel or Stainless Steel rollers. The contact tube, the groove of the roller
and the sleeve of the torch are all compatible with 0.8mm wire. Should you wish to weld 0,6 wire, use a torch of
maximum 3m long. The contact tip must be changed (fig II A / p.74) as well as the wire feeder's roller that must
be replaced by an optional reference (042339) with a 0.6 diameter groove. In this case, the position in such
a way to observe 0.6. For use with Steel, the gas requirement is argon + CO2. (Ar+CO2). The proportion of
CO2 required will vary depending on the use. For Stainless Steel, use the combination of 2% CO2 For specific
gas requirements, please contact your gas distributor. The gas flow in steel is between 8 and 12 Litres/minute
depending on the environment.
EASYMIG 130 / 140 / 150
.74)
p
5 : Polarity reversal cable
6 : Power Cable (2.20 m)
7 : Power switch
8 : Reel adaptor 100 mm (Easymig 130/140)
or 100/200mm (Easymig 150)
EN
17