df models KL-35 Manual De Instrucciones página 23

Adjusting the controller
> Switch the speed controller off and the transmitter on.
> Put channel 2 (accelerator/brake) into the "REV" position.
> Set the dual rate and EPA parameters on the sender to 100%
and switch off the ABS function.
> Press and hold down the set button (arrow) and switch on the
speed controller. As soon as the red LED begins to blink, imme-
diately release the set button.
1� Put the accelerator/brake lever into the neutral setting now
and press the set button again. The green LED will blink once
and a signal sound will be heard (once).
2� Put the accelerator/brake lever in the full speed position and
press the set button another time. The green LED will blink twi-
ce, and the signal sound will also be heard twice.
3� Put the accelerator/brake lever in the brake position and press
the set button again. The green LED will blink three times, and
the signal sound will also be heard three times.
The adjustment of the control range is now completed, and the motor can be started after 3
more seconds.
If you press the set button too long after the red LED has started blinking, the green
LED will blink and the controller has entered the programming mode. In this case,
switch the controller back off and start the adjustment again (steps 1-3).
-  -