df models KL-35 Manual De Instrucciones página 30

Programming step :
Presetting: 50%
Selection: 25%, 50%, 75%, 100%
Choose from four steps between 25% and 100% of the final speed for driving forward.
Programming step :
Presetting: previously selected drag brake setting
Selection: drag brake, 0%, 20%, 40%
In the standard setting, the brake force is set to the drag brake value. This will let the braking
action start softly without a break. The braking action can optionally also be set to 0%, 20%
or 40%.
Programming step :
Presetting: 9% (normal)
Selection: 6% (narrow), 9% (normal), 12% (broad)
A neutral zone can be set around the neutral position (a) of the accelerator/brake lever, in which
the lever can be moved without starting the motor or triggering the braking action.
Programming step :
Presetting: 15.00°
Selection: 0.00°, 3.75°, 7.5°, 11.25°, 15.00°, 18.75°, 22.50°, 26.25°
Different brushless motors need different control by the speed controller. It is therefore helpful
for ideal performance to adjust the timing to the respective selected motor.
Programming step 10: motor type
The speed controller is intended exclusively for brushless motors.
Programming step 11: Overheating protection on/off
Presetting: 95°C
Selection: 95°C, overheating protection off
The overheating protection of the controller is set to 95°C at the factory. The overheating pro-
tection can be turned off to prevent loss of control due to a motor cutoff in racing operation.
Setting the reverse speed
Setting the braking strength when the braking takes affect
neutral area
timing (only with sensorless motors)
- 0 -
1100_1101/V1/0110